J0825PM, QM Walk-On Scales Calibration

Jorgensen Laboratories, LLC | Loveland, CO 80538 800.525.5614 | fax 970.663.5042 | www.jorvet.com | [email protected] A MINIMUM 25% OF SCALE CAPACITY IS NEEDED IN ORDER TO CALIBRATE THE SCALE. (SCALE CAPACITY UP TO 250kgs OR 500lbs) TO ESCAPE OR ABORT CALIBRATION AT ANY TIME, PRESS THE ZERO/ON/OFF BUTTON J0825PM/QM - TECHNICAL BULLETIN Indicator Calibration for Walk-On Scales CALIBRATION u Turn on the scale. The indicator goes through a display test. When it becomes stable, you are ready to calibrate the scale. u With no weight on the scale, press the TARE and the ZERO/OFF/ON buttons at the same time and hold until the display shows CAL._? then release both buttons. u Press the TARE button, the display will show the maximum capacity of the scale, follow by CAL.P0 and then 0.0 with the last digit flashing. u Press the TARE button, the display will flash and show CAP.P1, you will need to key in a calibration weight of 125lbs. minimum or the calibration weight that you have. (A minimum 25% of scale capacity is needed in order to calibrate the scale.) Place the weight on the scale and key in your calibration weight from right to left by using the UNIT button to scroll your numbers up/down (↑↓) and use the HOLD/PRINT button to advance you to the left to enter your next number. Do this until the last digit on the left is flashing. u With calibration weight still on the scale, press the TARE button, the display will flash and display CAP.P2. You will then re-enter in your calibration weight from right to left, using the same procedure in the previous step. u Press the TARE button, the display will flash 0.0 and then return to the weigh mode. u Your scale is calibrated and should weigh correctly. NOTE - If error message CAL.Er appears repeat the procedure again. If this does not work with your scale, please call Jorgensen Technical Support. REMOVE AUTO OFF FUNCTION u Turn the scale on and be in the regular weigh mode for the scale. u Press and hold down the ON/OFF/ZERO and UNIT buttons until the word “SETUP” is displayed. This means the scale is in the SETUP mode. u Release the buttons. Your screen will display P1.05. This is factory default – 5 minutes of non-use and the scale will turn off. u You will want to change the value to P1.00 by selecting the UNIT button and then scroll through the numbers (↑↓), change to show a value of 00. If you need to change the second digit to the left, press the PRINT button and scroll through to the proper number selection by selecting the UNIT button. u Once you see P1.00 on the screen, then select the TARE button. The screen will now display P2.2. u Select the ON/OFF/ZERO to reset the indicator back into the normal weigh mode operation. NOTE - If you have batteries installed in the indicator, please remove at this time and use the AC adaptor supplied with the scale system.

Advanced Search

Find

Sort By

Hide thumbnail

By Item Number
By Keyword

History

Catalogs
TOC

Catalogs

TOC

Title Name	Pages	Delete	Url
Empty

Notes

Place note on desired page.

AI Assistant

Ask anything about this document

Back to Questions

Ai generated response may be inaccurate.

;

See All

Search Text Block

Hi $receivername|$receiveremail,

$sendername|$senderemail wrote these comments for you:

$message

$sendername|$senderemail would like for you to view the following digital edition.

Please click on the page below to be directed to the digital edition:

$thumbnail$pagenum

$link$pagenum

No Search Results Found

Page Number

J0825PM, QM Walk-On Scales Calibration

Advanced Search

Document History

AI Assistant

DISCLAIMER

Share Crop